Our customers in the USA are managed by JW Winco. Please, use the website of JW Winco: jwwinco.com
Our customers in the USA are managed by JW Winco. Please, use the website of JW Winco: jwwinco.com
T-angle linear actuator connectors GN 192.15 are based on T-angle connector clamps. The additionally provided mounting holes are used to connect to the drive key of a linear actuator. Bores with the designation G are equipped with sleeve bearings.
With the screw locations z2, the play of the guide bore d1 can be adjusted or the linear actuator connectors can be clamped after adjustment. Type B is equipped with seals at the screw locations.
For quick clamping without tools, the cap nuts can be replaced by the adjustable hand levers GN 911.3 listed in the table as accessories.
Stainless steel AISI CF-8
Matte shot-blasted
Sleeve bearing
Plastic (PTFE)
Carriage bolt DIN 603
Stainless steel
Cap nuts DIN 917 / Washers
Stainless steel
Seals
RoHS
| A | Without Seals |
| B | With seals |
| 4 | With stainless steel cap nut DIN 917 |
| d1 Bore with sleeve bearing | d2 Bore | b | d3 Mounting screws on the drive key | k1 Clamping length | k2 Clamping length | l1 | l2 | m | z1 Screw location | z2 Screw location | Accessory Recom. hand lever GN 911.3 for z1 l3 | for z2 l3 |
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| G 30 | B 30 | 22 | M 4 | 37 | 42 | 96 | 35 | 60 | M 8 | M 8 | 63 | 78 | 63 | 78 |
| G 50 | B 50 | 30 | M 6 | 65 | 75 | 151,5 | 48,5 | 103 | M 10 | M 10 | 78 | 92 | 78 | 92 |
Our service team is available from Monday to Friday between 7:00 AM and 5:30 PM: +49 7723 6507 - 0
