Product description
Toggle clamps GN 812 work according to the toggle principle. Lever and clamping bar move in the opposite direction. They require less space for the clamping action because the operating lever is located to the side below the clamp while in the clamped position. The two mounting surfaces oriented at 90° to each other allow for space-saving installation next to the clamping point.
Toggle clamps with forked clamping arm of type AV can accommodate an application-specific screw via the flanged washers. A clamping screw with rubber thrust pad is also included with type CV.
Toggle clamps of type EV can be adapted to special requirements by welding on the supplied clasp.
Specification
Tensioning mechanism
Steel
- Sheet metal parts
Case hardening steel C10, zinc plated, blue passivated - Bearing pins tempered
- Bearing rivets case-hardened
- Moving parts lubricated with special grease
Handle
Plastic
Red, oil resistant
Clasp for type EV
Steel zinc plated, blue passivated
Flanged washers GN 898 for type AV / CV
Steel
Zinc plated, blue passivated
Clamping screw GN 708.1 for type CV
- Steel, zinc plated, blue passivated
- Thrust pad
Chloroprene rubber (CR)- Hardness 85 Shore A ≈
- Vulcanized
- Black
- Type A (flat pressure area)
RoHS
Accessory
GN 804 Clamping Screws
GN 801 Holders for Clamping Screws (for Type AV)
GN 807 Clamping Screws (Steel)
GN 708.1 Clamping Screws (Steel)
GN 802 Clamping Screws (Steel)
GN 903 Clamping Screws (Steel)
