Product description
Swing clamps GN 875 are used when the clamping point for inserting and removing the workpiece must be freely accessible on top.
During the clamping action, the arm is first swiveled by 90° and lowered, followed by the linear tensioning motion. The workpiece clamping must take place within the clamping stroke.
The angle orientation of the tensioning arm can be set arbitrarily during mounting on the swing clamp. When tightening the screw, the piston rod must not experience any torque. The clamping arm must therefore be held to prevent twisting.
The swing clamps are equipped with a magnet ring piston and are therefore pre-fitted for end stop detection via sensor.
Specification
Swing Clamp
Aluminum
- Hard anodized
- Wear-resistant surface
- Double-action air cylinder
Max. pressure 6 bar
Socket cap screw ISO 4762
Steel
Zinc plated, blue passivated
Washer ISO 7092
Steel
Zinc plated, blue passivated
Flankenscheiben GN 898 bei Form A / AP
Stahl
verzinkt, blau passiviert
Clamping screw GN 708.1 bei Form AC
- Steel zinc plated, blue passivated
- Thrust pad
Chloropren-Kautschuk (CR)- Hardness 85 Shore A ≈
- aufvulkanisiert
- Black
- Type A (gerade Druckfläche)
RoHS
Accessory
Clamping Arms GN 875.2
Clamping Arms GN 875.3
Adapter Flanges GN 875.4
Sensor GN 3380
