Product description
Toggle clamps GN 810.4 are latched in both end positions. In the clamped position, this prevents unintentional opening or opening caused by vibrations; and in the open position, it prevents self-closing of the toggle clamp, such as due to an extended clamping arm. The latching can be disabled with a single hand to allow for opening / closing.
They work according to the toggle principle: lever and clamping bar move in the same direction. In the clamped position the operating lever is in its vertical position.
Toggle clamps in the U-bar version with two flanged washers (type VL) can accommodate an application specific clamping screw. A clamping screw with neoprene rubber tip is also included for type VLC.
Specification
Tensioning mechanism
Steel
- Case hardening steel C10
zinc plated, blue passivated - Bearing pins tempered
- Bearing rivets case-hardened
- Moving parts lubricated with special grease
Handle
Plastic
Red, oil resistant
Flanged washers GN 898
Steel
zinc plated, blue passivated
Clamping screw GN 708.1 for type VLC
- Steel, zinc plated, blue passivated
- Thrust pad
Chloroprene rubber (CR)- Hardness 85 Shore A ≈
- vulcanized
- black
- Type A (flat pressure area)
RoHS
Accessory
GN 801.4 Sensor Holders
GN 801 Holders for Clamping Screws
GN 801.1 Clamping Arm Extenders (for type MF)
GN 801.2 Clamping Arm Extenders (for Type UL)
GN 804 Clamping Screws
GN 807 Clamping Screws (Steel)
GN 708.1 Clamping Screws (Steel)
GN 802 Clamping Screws (Steel)
GN 903 Clamping Screws (Steel)
