GN 810 Toggle Clamps Steel, Operating Lever Vertical, with Horizontal Mounting Base

Toggle clamps GN 810 work according to the toggle principle: lever and clamping bar move in the same direction. In the clamped position the operating lever is in its vertical position.

Toggle clamps in the U-bar version with two flanged washers (type A) can accommodate an application specific clamping screw. A clamping screw with neoprene rubber tip is also included for Type C.

Toggle clamps in type E can be adapted to special requirements by welding with the supplied clasp.

Specification

Tensioning mechanism

• Steel
  • Sheet metal parts
    Case hardening steel C10, zinc plated, blue passivated
  • Bearing pins tempered
  • Bearing rivets (for size 230 and up) case-hardened
• Moving parts lubricated with special grease

Handle
Plastic
Red, oil resistant

Clasp for type E
Steel, zinc plated, blue passivated

Flanged washers GN 898 for type A / C
Steel, zinc plated, blue passivated

Clamping screw GN 708.1 for type C

• Steel, zinc plated, blue passivated
• Thrust pad
  Chloroprene rubber (CR)
  • Hardness 85 Shore A ≈
  • Vulcanized
  • Black
  • Type A (flat pressure area)

RoHS

Accessory

GN 801.3 Sensor Holders
GN 801 Holders for Clamping Screws (for Type A)
GN 801.1 Clamping Arm Extenders (for Type A)
GN 801.2 Clamping Arm Extenders (for Type A)
GN 809.1 Clamping Arm Extenders (for Type E)
GN 804 Clamping Screws
GN 807 Clamping Screws (Steel)
GN 708.1 Clamping Screws (Steel)
GN 802 Clamping Screws (Steel)
GN 903 Clamping Screws (Steel)